WiFi Wireless Gateway


WiFi Wireless Gateway Version 2



The WiFi Wireless Gateway eliminates the need for a Raspberry PI or Arduino computer to receive data from the Wireless RF Sensors. It is ready to go, no software to load or modify. It provides and alternate way to do the Celsius to Fahrenheit conversion if wanted, then send the readings to the PrivateEyePi server.

The WiFi Wireless Gateway follows the same process as our WiFi IoT Sensors to connect to the local WiFi and then establishes a connection to the PEP server. Differences between the Raspberry Pi or Arduino functions, is the WiFi Wireless Gateway is an Wireless RF sensor receiver only, it can be used to not issue commands to the Wireless RF Sensor.
The Gateway firmware is provided by Over the Air Firmware updates! When new features and fixes become available, one click update will download the latest Firmware and install the Gateway.
It supports a connection to an MQTT Broker and will publish all received sensor data as soon as received to the MQTT Broker.

Installation and Updates:

Features:
  • Easy to configure web interface. No programming or soldering skills required. You do not need the internet to configure the device. Connect to it directly from any WIFI device (e.g. PC, phone tablet…)
  • Supports both Celsius or Fahrenheit temperature conversion
  • Powered either by USB Mini cable (4.5V DC to 7V DC input) or battery connection (2.5V to 3.5V) via the 2 pin battery connection plug
  • The device supports dual WIFI mode allowing it to be WIFI access point and a WIFI client at the same time. A WIFI access point advertises itself through an SSID and can be connected to via any device or computer that has WIFI.
  • The Sensor List tab will show sensor that the WiFi Relay and heard and forwarded to the server. See Example below:

Required, but not included:

  • Mini USB cable and power supply (older cell phones used mini USB, so you may already have one in the bottom of a drawer). Any USB power supply will work.

Tech Specs:
  • Dimensions 74mm x 55mm x 28mm
  • Powered either by USB Mini cable and USB power supply, or battery connection (2.5V to 3.5V) via the 2 pin battery connection plug
  • Upgrades are done with Update button or can be manually done using a 3.3V FTDI cable